From The Shop

   

The Newsletter of the Lehigh Valley Woodworkers’ Guild

April  2005

Printed courtesy of HostwindowÔ 

 

Meeting: May 17,  2005   3rd Tues
Place:  

Lehigh County. Senior Center

1633 Elm St., Allentown, Pa. 

Program: 

This one is a surprise!

 

Thanks to:

Ron Wiley who volunteered his time and energy to help run the Guild.  He attended this first meeting on May 5 at Bob Tinsman’s house and he was up to speed in no time at all. 

 Allen Powell who volunteered to take over the “Blocks for Kids” program.  Allen will be looking for members to step up and give some of their time and energy to this good cause.  For those of you who might not know, the Guild has access to Bally Block’s scrap pile.  We turn this “scrap” into sets of blocks for kids in many of the Lehigh Valley childcare programs.

Speaking of Wood:

 Before the meeting got started we invited the members to visit the parking lot where Russ Reinhard had a truck full of wood from Bally’s scrap pile.  It did not take long for all of the  “scrap” to end up in member’s vehicles.  We will probably repeat this in the future as material becomes available.  The Turners were particularly happy to get free turning blanks…as usual.

 

 

 

April Drag-in & Brag-on:

The question has often been asked;  “Does Grumbine’s lathe ever stop”?  If it does, it cannot be for long because Bill just keeps bringin’ it on.  He was again first up with this beautiful piece in Cherry.

 


 

He followed with a large bowl of Wormy Maple.

 

 Gerry Chiusano, much to his credit, told us all the mistakes he made while making this Jewelry Box of Maple and Walnut.  He was able to correct them, and this fine work is the result.  After Gerry applies the finish he will give the box to his son. 

 

 

All of us in the audience who understand Italian had no trouble following Gerry’s hands.

 

 April Highlights:

We are fortunate to have some amazingly talented people in our Guild, but no one is more amazing than Adolph Schneider.  In previous presentations covering Veneering,  Marquetry and Inlay work Adolph demonstrated how these specialties were done.


 It is no surprise that few of us dabble in this demanding and esoteric facet of woodworking, and Adolph, in his desire to see more people carry this discipline forward, decided to show us just how easy it can be.  Craig Bentzley acted as Adolph’s able assistant for the evening.

 

Adolph started by demonstrating the use of a vacuum bag system to take advantage of Mother Nature’s atmospheric pressure gift of 14.7 PSI.  You must first have a table board that is perfectly flat to use as a base, which should be covered with plastic as a glue barrier. Both sides of a substrate material can be veneered at the same time.  Commercially available plastic bags are usually 20 mils to 30 mils thick, but success can be achieved with plastic as thin as 2 mils thick. It should be noted that plastic at least 10 mils thick would last longer.  Adolph uses a vacuum pump, but similar results can be achieved with a less expensive venturi system that uses a compressor that can pump at least 1.5 CFM.

Regardless of what system is used it is imperative that maximum squeeze is reached before the glue starts to set.  Glue with a longer open time is the rule.

 Adolph showed the “Scissor Board” he made to clamp veneer while he cuts it with veneer saw.  It is simple, but effective.

Adolph brought in two beautiful jewelry boxes to show and to explain how the Inlays and Marquetry were done.  He explained that with some patterns, and some really sharp tools, and practice, practice, practice on some inexpensive wood, we can build our expertise and have the confidence to take on a more difficult project.

 


  

If Adolph had no access to wood at all, he could still amaze everyone with his turnings of Corian glue-up.

 

Guild Website has been revised:

 

Lou Supina, our Webmaster has redone the website for your viewing pleasure.  You can check it out at www.lvwwg.com.

 If you would like a picture of yourself with something that you made put on the site, send a digital image to Lou at   Lou will make an announcement at the meeting on the best pixel size.  Lou’s phone number is on page 7 if you can’t wait.

 

 


WOOD 

SPECIALS

Information compiled by 

LEHIGH VALLEY WOODWORKERS’ GUILD

SHADY LANE TREE FARM

Louise & Mike Peters

5220 Shimerville Road

Emmaus, PA

610 965-5612 Please call

 5/4 Cherry  KD   $ 4.65 bf 

FLEETWOOD LUMBER & FLOORING

Bill Burkert

27 Rapp Rd.

Fleetwood, PA

610 944-8364 Please call

4/4 Lyptus (Hybrid substitute for mahogany or cherry) KD  $ 4.23 bf.

 Member discount 5%

 JOHN DECH

610 261-2938  Please call evenings after 7pm

 4/4 Walnut  Air dried  $ 2.50 / bf

 

BAILEY Wood Products, Inc.

441 Mountain Road

Kempton, PA

610 756-6827

 

Lehigh Valley Woodworkers’ Guild

lvwwg.com

Founded in 1995 by: Dave Dreher
Newsletter:
Art Silva  610-298-3285

Helen Patterson

Photography Gary Hunchar

610-253-1402

 

Hostwindow   hostwindow.com
Distribution / Mail list:
Bob Tinsman 610-691-3506
Special Projects Manager

Web Site Administrator :

Lou Supina

215-679-4234

Treasurer:
Harold Anderson 610-965-4828
Advisors / Contributing Writers

Bob Tinsman
Harold Andy Anderson
Quent and Helen Patterson
Ron Wiley

Art Silva
Lou Supina
Tom Wayne
Russ Reinhart

Printed by:

 (610) 366-0090